| |
AURELIA XL 4030
Description
Marine Oils resulting of the latest innovation occurring in additive component technology. They are specially designed for the lubrication of medium speed Diesel engines.
Recommended Uses
Turbocharged main and auxiliary engines of all types and all ratings running on Intermediate Fuel Oil or on Heavy Fuel Oil with high sulphur content. Bearings and stern-tubes. Reduction gear lubrication.
Properties
API service: better than CF
Excellent thermal stability.
Very good detergent properties at high temperatures.
Very good dispersant properties at low temperatures.
Good wear protection.
Very good oil film strength at extreme pressures.
Excellent water resistance.
Excellent capacity for centrifuging and for separating out water and insolubles.
Excellent filtration capacity.
Very good neutralizing capability of acidic products.
Quality level
AURELIA XL is the latest evolution of AURELIA range and satisfy the requirements and recommendations of the major engine manufacturers.
Technical propertie -
- |
UNITS |
METHOD |
VALUE |
VALUE |
Grade SAE |
- |
- |
30 |
40 |
Density at 15¡İC |
g/cm3 |
ASTM D 4052 |
0,915 |
0,920 |
Viscosity at 40¡İC |
cSt |
ASTM D 455 |
110 |
140 |
Viscosity at 100¡İC |
cSt |
ASTM D 455 |
12,0 |
14,0 |
Flashing point, open cup |
¡İC |
ASTM D 92 |
230 min |
230 min |
Freezing point |
¡İC |
ASTM D 97 |
-9 |
-9 |
T. B. N. |
mg KOH/g |
ASTM D 2896 |
30 |
30 |
Available in
Bulk and 185 Kg. Drums.
Hazard Identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Certain minimum precautions to avoid prolonged contact with the skin should be taken when handling. The use of gloves, visors or masks is recommended in order to avoid splashes
Health and safety hazards
Inhalation: Minimum risk of inhalation as it is a non-volatile product.
Ingestion: Does not provoke vomiting. Drink water. Seek medical assistance.
Contact with Skin: Wash with abundant water and soap.
Eyes: Wash with abundant water.
General measures: Seek medical assistance.
Fire fighting measure
No special measures are required.
Fire control: Foams, dry chemicals, CO2, water spray. Do not apply water jet directly as this may cause the product to spread.
Environmental precautions
Danger of physical contamination in the case of spillage (water flows, coastal areas, the ground, etc.) due to its floating capacity and oily consistency which may cause damage to fauna and flora with which it comes into contact. Avoid its penetration into water containers or outlets. Decontamination and cleaning: Treat as an accidental oil spillage. Avoid spreading by using mechanical barriers and eliminate using both physical and chemical means.
Unless otherwise specified, the values cited in technical characteristics should be considered typical.
|
|
